OSHA 10 Hour Training (General Industry)

OSHA 10 Hour Training – General IndustryInstructor-led

This Instructor-led, OSHA 10-Hour General Industry training program is intended to provide students with an overview of the basic health and safety hazards present in the workplace. The OSHA 10 hour general industry training course also provides students with an overview of how the Occupational Safety and Health Administration (OSHA) operates. There are no prerequisites required to take the 10-hour general industry course.

The OSHA 10 hour training course for general industry is based on the OSHA 1910 standards. We also address state-specific OSHA requirements, where applicable. This OSHA 10 hour training course is designed for workers in most factories and manufacturing operations, healthcare industries, transportation and warehousing, chemical plants, oil and gas production operations, and service industries.

The OSHA 10 hour training course in general industry standards was created by OSHA, who has authorized certain OSHA Outreach trainers to conduct this 10-hour training class for a group of workers. The OSHA 10 training courses are presented in a classroom setting (usually spread over two consecutive days).

osha compliance audit

When a student successfully completes the OSHA 10 hour General Industry training course, they will receive the official USDOL / OSHA 10 hour General Industry course wallet card as well as a personalized certificate of training. The cards are accepted in all 50 states and the US territories.

This training can be conducted at your location or at our training center in the Tampa, FL area.

Here are the mandatory topics that will be covered in the OSHA 10-hour general industry training course. These topics take approximately seven hours to cover:
  • Introduction to OSHA
  • Walking and Working Surfaces
  • Exit Routes, Emergency Action Plans, Fire Prevention and Protection
  • Electrical
  • Personal Protective Equipment
  • Hazard Communication
The balance of the 10 hour general industry training on site training course can be used to cover a few of the following topics:
  • Hazardous Materials
  • Material Handling
  • Machine Guarding
  • Lockout – Tagout
  • Fall Protection
  • Introduction to Industrial Hygiene
  • Bloodborne Pathogens
  • Ergonomics
  • Safety and Health Programs

Don’t miss our another training programs.